SAE J1816 Performance Levels and Methods of Measurement of Electromagnetic Radiation From Vehicles and Devices, Narrowba

作者:标准资料网 时间:2024-05-24 20:12:46   浏览:9074   来源:标准资料网
下载地址: 点击此处下载
Product Code:SAE J1816
Title:Performance Levels and Methods of Measurement of Electromagnetic Radiation From Vehicles and Devices, Narrowband, 10 Khz to 1000 Mhz (Cancelled Jun 1996)
Issuing Committee:Electromagnetic Compatibility (Emc) Standards
Scope: With the advent of computer based electronics being utilized in automobiles, the Electromagnetic Radiation Subcommittee has deemed it prudent that a new test method be written to provide a common test for the measurement of narrowband radiation from vehicles and devices. This SAE Standard covers methods of measuring incidental narrowband radiation from vehicles and devices. The standard also establishes performance levels intended to protect nearby communication and broadcast receivers. It is intended to serve as an alternate method of measuring electromagnetic radiation which is analogous to the FCC Part 15 methodology but adapted to measuring vehicles. The equivalent procedures for broadband emissions are set forth in SAE J551. This standard covers narrowband emissions in the frequency range of 10 kHz to 1000 MHz. An example of such radiation is the unintended emission from on-board logic and computer modules. In particular, the standard is intended to provide protection to adjacent mobile communication and broadcast receivers (vertical E-Field test) and portable broadcast radios (magnetic field test). In the future horizontal E-Field measurement requirements will be considered.
下载地址: 点击此处下载
基本信息
标准名称:切向夹紧器
中标分类: 航空、航天 >> 航空器与航天器制造用设备 >> 夹具
替代情况:HB 633-74
发布日期:1989-05-13
实施日期:1989-12-01
首发日期:1900-01-01
作废日期:1900-01-01
出版日期:1900-01-01
页数:3页
适用范围

没有内容

前言

没有内容

目录

没有内容

引用标准

没有内容

所属分类: 航空 航天 航空器与航天器制造用设备 夹具
基本信息
标准名称:单端荧光灯的安全要求
英文名称:Single-capped fluorescent lamps - Safety specifications
中标分类: 电工 >> 电气照明 >> 电光源产品
ICS分类: 电气工程 >> 电灯及有关装置 >> 荧光灯、放电灯
替代情况:替代GB 16843-1997
发布部门:中华人民共和国国家质量监督检验检疫总局 中国国家标准化管理委员会
发布日期:2008-06-13
实施日期:2009-07-01
首发日期:1997-06-03
作废日期:
主管部门:全国照明电器标准化技术委员会(SAC/TC 224)
提出单位:中国轻工业联合会
归口单位:全国照明电器标准化技术委员会(SAC/TC 224)
起草单位:中国质量认证中心
起草人:陈松、陈尚瑜、李锴、邢合萍、徐国荣等
出版社:中国标准出版社
出版日期:2009-07-01
页数:24页
计划单号:20063036-Q-607
适用范围

本标准规定了使用下列灯头的普通照明单端荧光灯的安全要求:2G7、2GX7、GR8、2G10、G10q、GR10q、GX10q、GY10q、2G11、G23、GX23、G24、GX24和GX32。
本标准规定了制造商根据成品灯的检验记录确定全部产品符合本标准要求的具体方法。此方法也可以用于产品认证。本标准还规定了评定批量产品的检验程序细则。

前言

没有内容

目录

前言Ⅰ 1 一般要求1 1.1 范围1 1.2 规范性引用文件1 1.3 定义1 2 安全要求2 2.1 总则2 2.2 标志2 2.3 灯头的机械要求2 2.4 绝缘电阻3 2.5 介电强度3 2.6 可能会意外带电的部件3 2.7 耐热与防火3 2.8 灯头的爬电距离4 2.9 灯头温升4 2.10 抗无线电干扰电容器4 2.11 灯具设计参数4 2.12 镇流器设计参数4 3 评定4 3.1 总则4 3.2 采用制造商记录方法对全部产品评定5 3.3 制造商特定试验记录的评定5 3.4 批量拒收条件5 3.5 全部产品试验的抽样程序6 3.6 批量试验的抽样程序6 附录A (规范性附录) 评定灯头结构和组装的试验10 附录B (规范性附录) 灯头最高温升和测试方法11 附录C (规范性附录) 灯具设计参数13 附录D (规范性附录) 型式试验的合格条件14 附录E (规范性附录) 阴极与插脚的连接方式15 附录F (规范性附录) 灯的非互换性要求16 附录G (规范性附录) 加热试验温度17 附录H (资料性附录) 镇流器设计参数18 参考文献19

引用标准

下列文件中的条款通过本标准的引用而成为本标准的条款。凡是注日期的引用文件,其随后所有的修改单(不包括勘误的内容)或修订版均不适用于本标准,然而,鼓励根据本标准达成协议的各方研究是否可使用这些文件的最新版本。凡是不注日期的引用文件,其最新版本适用于本标准。
GB/T5169.10 电工电子产品着火危险试验 第210部分:灼热丝/热丝基本试验方法 灼热丝装置和通用试验方法(GB/T5169.10-2006,IEC60695-2-10:2000,IDT)
GB7000.1-2007 灯具 第1部分:一般要求和试验(idtIEC605981:2003Luminaires-Part1:Generalrequirementsandtests)
IEC60061-1 灯头、灯座及检验其互换性和安全性的量规 第1部分:灯头
IEC60061-2 灯头、灯座及检验其互换性和安全性的量规 第2部分:灯座
IEC60061-3 灯头、灯座及检验其互换性和安全性的量规 第3部分:量规
IEC60410 计数检查抽样方案及程序
IEC60529:1989 外壳防护等级(代码:IP)
IEC60901 单端荧光灯 性能要求

所属分类: 电工 电气照明 电光源产品 电气工程 电灯及有关装置 荧光灯 放电灯